Plumber Wellington, Fl

Plumber Wellington, Fl Plumbing Services

It’s important for a new homeowner to know where the location of the sewer line cleans out are. It’s also important to know where the main shut office in the house. To find the clean out in the house, you will need a set of plans for the house.

A new homeowner can get a set of plans from Wellington city or Palm Beach County. Now if the plans are not available. Then what we try to do is to locate the three or 4-inch sewer line. The first thing that you need to do is to go and find out if you are in a septic tank or city sewer.

A cleanout can be located if you find a vent stack on the top of the roof. The vent stack is where the sewer gas leaves the piping system and conducts the air as well.

When you are directly in front of it facing your house, go to Home Depot and get a probe that you can dig in the sand real easy. Then insert the probe into the ground to see if you can find the cleanout.

When the probe hits the PVC pipe you will realize it’s location. The cleanout is generally 5 feet off the house. So if you dig down about 14 or 18 inches you will find the cleanout cap, this is where you clean the sewer line with a plumbing snake to handle the root penetration. This can be very helpful to the plumber to handle the house stoppage. Because you can never know when this problem may happen so if the problem happens at night it’s much easier to handle.

The location of the main shut off for the house.

The main shut off is a valve that closes all of the water flow into the residence. Some houses have a 1 1/4 inch house supply for four or five bathrooms in the house. Some houses have a 3/4 supply feed. Being a new homeowner is important to know its location in case of emergency.

When you locate the water valve it should be tested to make sure that the water was completely turned off. Many times the old houses have gate valves which over the years do not close correctly or the gate breaks and completely closes the water supply. If that’s the case you should have a plumber replace the gate valve with a single handle ball valve.

The reason why because the ball valve is much easier to close then the gate valve and many years of good service. The best way to locate the shut off valve on the house is to go around the house and inspect all the hose bibs and see if there is a pipe coming up out of the ground for a supply this would be your main location. It is very important that also a homeowner has a curb key to the water meter as well.

If there are any questions about plumber Wellington service please call Hardenburgh plumbing at 561-968-0000.